MasterCraft 200V Manuale dell'Operatore Scaricare il pdf (Pagina 17)

5.3 How to use the holster

The holster is used to protect the meter and to make the measurement more comfortable.

It comes with two stands installed together. The figure shows how to use the holster to:

Support the meter with a standard angle.

Support the meter with a small angle using the little stand

Hang the meter on the wall using the little stand. Take the little stand off from the bac

side of the large stand and insert it into holes located upper on the holster.

Hold test leads.

-24-

6. BATTERY & FUSE REPLACEMENT

If the sign” ”appears on the LCD display, it indicates that battery should be replaced.

Remove screws on the back cover and open the case. Replace the exhausted battery with a

new one.

Fuse rarely need replacement and blow almost always as a result of the operator’s error.

Open the case as mentioned above, and then take the PCB out from the front cover. Replace

the blown fuse with same ratings.

WARNING

Before attempting to open the case, be sure that test leads have been disconnected from

measurement circuits to avoid electric shock hazard.

For protection against fire, replace fuse only with specified ratings: F 200mA/250V (quick acting).

-26-

PRECISION MASTECH ENTERPRISES CO.

Room 1708-09, Hewlett Centre, 54 Hoi Yuen Road,Kwun Tong, Kowloon, Hong Kong.

Tel:852-23430007 Fax:852-23436217 E-mail:[email protected]

SHENZHEN HUAYIMASTECH CO., LTD.

East Wing,8/F., Block 4,Saige Science and Technology Industria Garden,Hua Qiang Bei

Rd.Shenzhen, China

Tel:0755-83769588 Fax:0755-83768150 E-mail: [email protected]

DONGGUAN HUAYI MASTECH CO.,LTD.

Yulianwei Industrial Area, Qingxi Town, Dongguan,China

Tel:0769-7318228 Fax:0769-7318225

HYS004226

1 2 ... 12 13 14 15 16 17

Nessun commento

MasterCraft 200V Manuale dell'Operatore Pagina 17